-40%
SMD CROSSOVER CALIBRATOR CC-1
SMD CROSSOVER CALIBRATOR CC-1
SMD CROSSOVER CALIBRATOR CC-1
SMD CROSSOVER CALIBRATOR CC-1

SMD CROSSOVER CALIBRATOR CC-1

$ 98.2

Availability: 1085 in stock
  • Item must be returned within: 30 Days
  • Country of Manufacture: United States
  • Condition: New
  • Brand: Steve Meade Designs
  • MPN: Does Not Apply
  • Refund will be given as: Money Back
  • Return shipping will be paid by: Buyer
  • Restocking Fee: No
  • All returns accepted: Returns Accepted

    Description

    BRAND NEW
    SMD CC-1
    CROSSOVER CALIBRATOR
    The purpose and benefit of the D’Amore Engineering / SMD Crossover Calibrator CC-1.
    The purpose and benefit of the D’Amore Engineering / SMD Crossover Calibrator.
    Most modern car audio
    amplifiers
    have a built in crossover on the side. Usually, it will start at 30hz and have a huge gap, all the way up to (sometimes) 500hz. The purpose of this tool is to enable the installer to set the crossover frequency of an electronic crossover to the desired frequency, accurately and quickly. Enter "Competition Mode" and easily match gains on any 4-channel amplifier or even multiple bass amplifiers. This is VERY important when using subwoofers that share a common chamber, especially if you have 2 (or more) amplifiers on a dual voice coil driver.
    What is included?
    The Crossover Calibrator (CC-1)
    Protective silicon rubber boot
    Calibrated Test tone CD
    Harness
    This manual
    Pride of ownership
    About the design
    When you pick up the CC-1, know that you are holding a precision piece of equipment. If treated as such it should provide you with many years of reliable service. We have chosen a 9V battery as a power source for a few reasons:
    They are readily available
    Isolating the CC-1 from the vehicle’s electrical system for power, guarantees that it will only measure what it is supposed to measure; the audio signal, not
    noise
    in the charging system.
    We also chose an
    RCA input
    connector for a few reasons:
    It makes it pretty easy to measure the output of a headunit directly, if you choose to do so
    Should the harness become damaged it is easily replaceable or repairable in the field
    Specifications
    Everyone hides these in the back of the book. We are proud of our specs, they aren’t lies, so we are putting them up front.
    The Crossover Calibrator’s circuitry is digital microprocessor controlled
    Crossover -3dB point accuracy +/- 0.25dB
    Low Battery LED trigger battery voltage < 6.5Vdc
    Auto-shut off timer 8 - 10 minutes after ON button is pressed
    Check out my
    other items
    !