Autobahn AP-8320 Epoxy Primer Surfacer DTM 2 Gallon Kit Car Vehicle Auto Gray

Description

AP-83
20
Epoxy Primer
(Gray)
AP-8300 Epoxy Activator
Surface Preparation
Bare Substrates Solvent wash surface with a good grade wax and grease remover such as AS-2900 and wipe dry with a clean cloth. Apply three single wet coats of AP8320/AP-8300 Series Epoxy Primer according to instructions on data sheet.
Surface Preparation
Prepainted Substrates
Wash surfaces with a mild detergent and hot water. Rinse with clean water and wipe dry with a clean cloth. Solvent clean with AS-2900 Clean Ease. Wipe dry with a clean cloth. Sand original paint and repair damaged areas with a good quality non-staining body filler. For spot repairs, scuff sand area where primer will be applied. For overall refinishing, scuff sand the entire car with 320 grit sandpaper or fine scuff pad.
Mixing Directions
1 Part AP-8320 Epoxy Primer and 1 Part AP-8300        Epoxy Activator ≤25% AR-2040, AR-2050, AR-2060 Uni Reducer Series
Application
Use conventional spray or airless. Relative humidity should be below 85% min cure temperature 40ºF.
Drying Schedule
Dry times are based on recommended film thickness and are dependent on ambient temperature. Excessive film thicknesses, low temperature and poor air movement will retard dry times.
Tack Free   1 hour Recoat        6 hours
Pot Life       Six hours at 60-70ºF.
Technical Data
Weight Solids 60% Mixing Ratio 1:1 Pot Life 6 hours Volume Solids Package 54%Viscosity 75 ± 2 KU   Recommended Film Thickness 2.0 to 3.0 mil Flash Point 80ºFTCC Induction Time 10 min Coverage @ 1 mil 752 sq ft/gal Max Temperature 250ºF Air Pressure @ Gun 45-50 psi Gloss Flat
Products
AP-8320 Epoxy Primer (Gray) AP-8300 Epoxy Activator