AP-8116 BLACK SLICK-SEAL PRIMER/SEALER (QUART) READY TO SPRAY (AP-8116)

Description

AP-8116 BLACK SLICK-SEAL PRIMER/SEALER (QUART) READY TO SPRAY (AP-8116)
AP-8116 Slick-Seal Primer/Sealer is an excellent quality, low build primer/sealer. AP-8116 is fast drying can create a uniform surface without a lot of film build. Slick-Seal provides excellent adhesion to fully cured painted surfaces, treated and primed steel, properly prepared aluminum and fiberglass. Slick-Seal may be topcoated with a variety of topcoats such as basecoat, lacquer or enamel.
Surface Preparation
Solvent wash surface with a good grade wax and grease remover such as AS-2900 and wipe dry with a clean cloth. Sand original paint and repair damaged areas with a good quality non-staining body filler. For spot repairs, scuff sand area where sealer will be applied. For overall refinishing, scuff sand the entire car with 320 grit sandpaper or fine scuff pad. one to two single wet coats of Slick-Seal to achieve the uniform color desired.
Mixing Directions
1 Part Sealer Ready to spray
Application
Adjust air pressure at the gun to 30-45 psi for siphon feed guns. Use less pressure to minimize over spray on small jobs. Apply 1-2 medium wet coats at a gun distance of 8-12 inches as needed. Allow 5 to 15 minutes flash time between coats. Recoat times will vary with temperature, air movement and film thickness. Insufficient flash time will promote slow hardness development of the topcoat system. Allow final coat to dry 30 minutes to 1 hour before topcoat.
****ALSO AVAILABLE IN GALLONS AND IN WHITE, RED AND GREY COLOR****
PROVISION Auto Body Supply
Providing Quality to Professionals. Buy with confidence.
ALASKA AND HAWAII EXTRA SHIPPING COST
Check out my
other items
!
for great deals.
Be sure to add me to your
favorites list
!
Sign up for my email newsletters
by adding my eBay Store to your Favorites